Trang

Nhãn

Chủ Nhật, 30 tháng 11, 2014

Easy Tom Tuning Tips: Understanding How To Get The Best Sound for Your Kit's Toms

By Victor Salazar














Tuning tom toms often confuses many drummers. It could be because, frequently, drummers do not tune them to specific notes. There are, of course, some exceptions - like the amazing Terry Bozzio, who tunes the 31 toms on his massive kit both chromatically and diatonically. The other aspect that can make tuning toms a bit more complex than tuning a snare drum or bass drum is that toms produce a lot more overtones. These extra overtones can occasionally make it difficult to hear the true pitch of the drum.

So then how are we supposed to tune our toms if we are not tuning them to specific notes and we have to deal with the complexity of their overtones? I would like to present some fundamental tuning guidelines that can help any drummer attain the desired tone and sound from their toms.

Don't Tune Your Toms While They Are Set Up

Most drummers understand the basic rule of tuning - tap along the perimeter of the drum near each tension rod, choose a pitch, and tune each tension rod to attain the same pitch all the way around. The mistake a lot of drummers make, however, is that they try to tune the toms while they are set up. The problem with this method is that you are hearing both heads resonating fully as you tap, and cannot accurately hear the specific pitch that you're trying to attain.

The first step that I always suggest when tuning your toms is to remove them from their stands or mounts and put them on a soft surface (like a drum throne), one at a time. This applies to floor toms as well. When you do this, you are now only hearing one head at a time, which makes it much simpler to distinguish the true pitch of your drum/toms.

Relationship Between the Heads

Unless you are using a single headed concert tom, your toms consist of two heads. The relationship between the two heads plays an important role in their sound. Generally, the bottom or resonant head should be tuned slightly higher than the batter side or the head that you strike. The batter head gives you the desired pitch and the bottom head helps the drum to hold that pitch. If the bottom head is tuned too low, you may get a funny pitch bend that descends. Alternately, if the resonant head is tuned too high you will get the opposite effect with a pitch bending upward.

When assessing the relationship between the heads, I like to place the drum on its side on a soft surface (like a drum throne) to preserve the finish. Then, I mute one head with one hand while striking the opposite head with my other hand. By muting one head while tapping the other, I can clearly hear the pitch of each head since I'm only listening to one head at a time. If I determine that the relationship between the two heads is off, but I know that the drum is in tune in terms of equal tension on all of the rods, I can quickly raise or lower the pitch of both heads by systematically turning each tension rod an equal number of turns either clockwise or counterclockwise.

I hope these basic guidelines help you tune your toms more consistently and efficiently. Just remember to stay relaxed and take your time. Your tuning skills will progress over time to the point where it becomes second nature.

Good luck!




About the Author:



Không có nhận xét nào:

Đăng nhận xét

Tổng số lượt xem trang